Published at Wednesday, 07 November 2018. Sectional Sofa. By Jennie Morgan.
The hinge sides on the ottoman frame bottom and slide them into the. U clips, on the ottoman top, while sliding the hinge sides of the ottoman top into the U clips on the ottoman bottom, making sure this step forms the ottoman box with square corners now screw in the four legs through the pre-drilled holes in each corner of the ottoman frame. Bottom into the four support rods making sure the legs are tight and straight turn the ottoman box over onto its legs and carefully work. The ottoman liner over the assembled ottoman box making sure to keep corner seams of the Ottoman liner on the corners of the ottoman box, now secure the ottoman liner to the assembled ottoman box with the hook and loop strips next slide. The ottoman slipcover over the assembled ottoman and liner securing it under the edge of the ottoman base using the hook and loop strips place, the seat cushions back cushions and toss pillows sit back and enjoy your new sofa sectiona. You
Connectors pushing down firmly in a quick motion. Repeat the procedure for the other side, then secure the backs with three black hand, bolts, one in each arm and one inserted from right to left inside the back. Securing the two backs together. Threading into the silver T nut until tight next apply the slipcover to the sectional pay, close attention to straighten the front arm panels and skirt attach the hook and loop strips in the inside back and outer arm for a better fit next place. The ottoman frame top face down allowing the hinged wings to open upward now securely screw in the for support rods into the holes at each corner of the ottoman frame top next open.
Insert one black hand bolt into the bottom hole from left to right threading it into the embedded T nut, make sure all hand bolts are screwed in completely and tight now secure the to seat boxes by placing the center frame support over the inside edges, where the Seat boxes meet at the top lining up the holes on the support with the holes on the seat boxes, secure the center frame support by inserting two black hand bolts from left to right through the holes of the support and box threading them into the silver tea Nuts, until tight put one wing nut on each of the two hands, bolts securing the center support and tighten them securely.
Any content, trademark’s, or other material that might be found on the edijardin.com website that is not edijardin.com’s property remains the copyright of its respective owner/s. In no way does edijardin.com claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.
Copyright © 2018 edijardin.com. All Rights Reserved.